Skip to content
English
  • There are no suggestions because the search field is empty.

Instructional Videos for Sparrow

Below are the description and videos that show the process of activating and putting sensor back to sleep for BLE Beacon.
 

Video 1: Waking Up

·         No LED activity at first.

·         Locate the magnet symbol on the end cap.

·         Place the magnet on the body of the enclosure adjacent to the magnet symbol as shown.

·         Hold for 5 FULL seconds then remove magnet.

·         After another 5 seconds, the green LED will flash slowly 3 times.

·         After another 3 seconds, the device will reset and begin the normal join procedure.

 

Video 2: Activating sleep mode

·         Device must be in the process of trying to join the network (rapid green LED flashes with a red LED flash every 10s).

·         Locate the magnet symbol on the end cap.

·         Place the magnet on the body of the enclosure adjacent to the magnet symbol as shown.

·         Hold for 5 FULL seconds then remove magnet.

·         After another 5 seconds, the rapidly flashing green LED should stop.

·         After another 3 seconds, the device will reset (both red and green LEDs come on briefly) then the greed LED will flash quickly 3 times.

·         The device is now in DEEP SLEEP mode.